recently i wrote up a post about having troubles getting my MPLE sharp so i just thought i'd state that it is now very sharp and now i love it.

the sharpmaker wouldnt touch it at first.

i went a tried giving it a convex edge but for whatever reason i dont have good luck giving smaller blades convex edges and i screwed up the tip.

a few days latter i ground it back out to a V grind,fixed up the tip and then put it on the sharpmaker for a final touch up and polish.

now it is perfect and ready for EDC.

thanks especially to horndog for all you advice and offer to help me out and to everyone else who gave me advice.

while i understand a lot of the problem was me i am a much bigger fan of the busse kin stainless again.

now if i could only see those MPLE test dan promised...lol