Are you sure that picture wasn't from the French and Indian war ?

Coulda been. I get my dates mixed up sometimes.

Great comeback Randy !

Well my fellow Dogs, the FULL Hearing Protection Act has officially made it into the Reconciliation (the D’s Big Beautiful Bill) bill and will now (once signed) REMOVE suppressors from the NFA. Meaning a form 4473 is all that will be necessary to purchase this vital hearing protection devices. With NO TAX STAMP Extortion fee!

Got my CZ Scorpion EVO S2 fixed today. You see I tried replacing the recoil spring with a 125% increased spring rate.
The recoil Spring guide rod has a PLASTIC buffer pad on the end of it. The little nipple that goes inside the rod is only about 1/8 inch and about 1/4 inch long. I snapped the pad off the nipple.

Well this new guide rod is a solid piece of steel with a steel buffer pad welded to it. MUCH better set up than the OEM system. And it came with a new 125% Spring and new roll pins to put it all together through the BCG.

I’m satisfied it’s gonna work a lot better. Now all I need is to get a can for it.

BUT NEXUS Firearms makes basically a Scorpion Clone that is all aluminum and steel with NO PLASTIC except for the grip and trigger assembly. I mean Christmas is only 196 days away.

WOO HOO! Eight days ago I talked about getting my Scorpion EVO 3 S2 fixed from where I broke the recoil block off the back end of the recoil spring guide rod. I DID get it fixed. unfortunately Two days ago I found out I installed a part in the wrong place. And yeah it was ALL my fault. The picture clearly showed where the little rod guide went IN FRONT of the Spring. Yeah, I put it in at the END of the spring.

Well, this time after thinking about how to do this easier, I finally got it done in about 10 minutes or less. NOW it works the way it is supposed to.

I THINK it would have worked fine as it was without any danger, but it just wouldn’t have had the extra 25% dampening effect it was suppose to have.

So now that it’s all back together the way it’s supposed to be I can go ahead and once again concentrate on a 9mm Can for it. BUT I think I’m gonna wait until after Suppressors, SBRs and SBSs come off the unconstitutional NFA list so there will not be any tax stamp necessary, just a normal 4473 NICS check.

It’s been a good day.

It pays to read the instructions first.

Twern’t no in structions. Just pitchers. I reckon I had’em turnt upside down.

Then you should have read them standing on your head !

You Marines, an answer for everything.

Since you can’t read, pictures should have been good enough.

I guess the pictures should have been cartoons.