Scrap Yard Discussion Forums

Previous Thread
Next Thread
Print Thread
Page 5 of 5 1 2 3 4 5
Re: anyone herd form SYKCO? [Re: KnotSlip] #581015 06/20/11 08:37 PM
Joined: Jun 2011
Posts: 20
A
AndrewS Offline
Pound Puppy
Offline
Pound Puppy
A
Joined: Jun 2011
Posts: 20
Quote
I hear ya Andrew. Hopefully you will like it and if not I'm sure there will be future releases that are more to your liking. They did post pics and explanations regarding the handle gaps but I guess you missed the post. They shouldn't cause any issues though and I think if you look up the post on it they even recommend a way to deal with them (remove them). Good luck!

I'll post it if I find it later.

No, I caught it. It wasn't posted until after I had placed my order though. I think I even had a shipping notice prior to the post. I don't think it is going to be a problem though. I've intentionally tried to rust it through some typical neglect one might expect after a hard days use and not so much as a spot appeared. Not bad for not being stainless.

Re: anyone herd form SYKCO? [Re: Toast] #581016 06/20/11 08:52 PM
Joined: Oct 2008
Posts: 116,538
SkunkHunter Online Content
Junk Yard Dog
Online Content
Junk Yard Dog
Joined: Oct 2008
Posts: 116,538
Quote
Dan did mention the small gaps in the Res-C. At least the sizing ones for different designs. I haven't read any reports of problems with rusting from any infi/res-c handle gaps. If you decide to keep and use it and you're worried you cen fill the gaps with something.

The Gaps only go back about 1/16 or maybe at most 1/8 inch. Dan showed a pic of how to trim them off but I don't remember where.


A Little Paranoia Will Keep
You Safe (ALPWKYS)

Be a Sheepdog
JYD#105
Re: anyone herd form SYKCO? [Re: SkunkHunter] #581017 06/20/11 08:55 PM
Joined: Oct 2008
Posts: 116,538
SkunkHunter Online Content
Junk Yard Dog
Online Content
Junk Yard Dog
Joined: Oct 2008
Posts: 116,538
Ok, I didn't read all the posts before posting the above.


A Little Paranoia Will Keep
You Safe (ALPWKYS)

Be a Sheepdog
JYD#105
Page 5 of 5 1 2 3 4 5

Powered by UBB.threads™ PHP Forum Software 7.7.3