I have a question regarding the Cordura "Sheath for 10" knives". I purchased the sheath before the knife(bought the sheath last week). I just got the knife today. When I put the brand new dogfather knife in to the sheath, the knife cut through the bottom of the sheath. About 2 inches of the knife is exposed through the bottom of the sheath. I did not force the knife into the sheath. I just slid the knife in, not forcefully (i literally took the knife out of the cardboard sheath and placed it into the cordura sheath).
Also, even if i secure the knife using the top snap/buckle a small portion of the knife pokes through the bottom of the sheath. I did not think this should happen, especially since the knife is advertised for the dogfather.
I did not even know that the knife had cut through the sheath. The dogfather went through the bottom of the sheath like butter. I guess this is a testament to how sharp the knives are from the factory, its unfortunate that I had to waste 20 on a sheath that does not seem to actually fit the knife.
Has anyone else had this problem? or can you send me a picture of what your dogfather looks like in the scrapyard 10 in cordura sheath.
Any comments or suggestions would be greatly appreciated!!
Here is the knife going through the sheath:
http://picasaweb.google.com/chamm79/UntitledAlbum?feat=directlink#5514341243004334610Even when the knife is secured, a small portion of the knife pokes through:
http://picasaweb.google.com/lh/photo/VKphcjxWr4GRFMiAarTqew?feat=directlink