Regulator grind angle? PLEASE HELP! - Scrap Yard Discussion Forums

Scrap Yard Discussion Forums

Register Log In Scrap Yard Knife Company Forums Knives Forum Regulator grind angle? PLEASE HELP!

Print Thread

Regulator grind angle? PLEASE HELP! #563191 12/17/10 06:36 PM
Joined: Apr 2010 Posts: 12 Snake OP Pound Puppy
OP Snake Pound Puppy Joined: Apr 2010 Posts: 12	Can anyone tell me what the factory grind angle on the regulator is. It would help me out a lot. Also, is it a straight grind or is it some other type of grind such as convex or concave, etc. SNAKE Don't Tread On Me!

Re: Regulator grind angle? PLEASE HELP! [Re: Snake] #563192 12/18/10 06:54 AM
Joined: Oct 2008 Posts: 116,990 S. E. Missouri SkunkHunter Junk Yard Dog
SkunkHunter Junk Yard Dog Joined: Oct 2008 Posts: 116,990 S. E. Missouri	Snake, I don't know the angle, but Gustimate is probably 20degrees. It is just a regular (secondary grind) V shaped as far as I can tell. I am sure others more knowing than I will also answer you. It's a stout one though! If you’re not Paranoid, You’re not paying attention Be a Sheepdog JYD#105

Re: Regulator grind angle? PLEASE HELP! [Re: SkunkHunter] #563193 12/18/10 09:39 AM
Joined: Apr 2010 Posts: 493 Michigan knifenut1013 Mongrel
knifenut1013 Mongrel Joined: Apr 2010 Posts: 493 Michigan	Edge or main grind?

Re: Regulator grind angle? PLEASE HELP! [Re: knifenut1013] #563194 12/18/10 09:44 AM
Joined: Oct 2008 Posts: 116,990 S. E. Missouri SkunkHunter Junk Yard Dog
SkunkHunter Junk Yard Dog Joined: Oct 2008 Posts: 116,990 S. E. Missouri	I figure he is talking about the secondary (edge) grind but I could be wrong. If you’re not Paranoid, You’re not paying attention Be a Sheepdog JYD#105

Moderated by ColdOne, Dumpster Dan, Patti, Private Klink, ScrapSquatch, SkunkHunter

Powered by UBB.threads™ PHP Forum Software 7.7.3