Many of you know how much I love my SRKW Chopweiler but sometimes it's just a tad more knife than I need, I decided that I wanted something in between my Chopweiler and my M6 in size but also thinner outta 3/16" stock.
An obvious pick would have been a Busse Sarsquatch but my wallet is way too light for one of those ( One day by hook or by crook I will own one ! )so I had to go the custom route.
Anyway after a little sketching I sent my design off to one of my favourite makers and this is the result.
Not a Busse-Kin blade but I am very pleased with it !!! <img src="/ubbthreads/images/graemlins/smile.gif" alt="" />

Very nice pit! Bryan makes some great blades. And crazy sharp

Clean and simple....nice! <img src="/ubbthreads/images/graemlins/wink.gif" alt="" /> <img src="/ubbthreads/images/graemlins/thumbup.gif" alt="" /> <img src="/ubbthreads/images/graemlins/thumbup.gif" alt="" />

very nice blade.

Nice blade profile on that one.

I like it! What steel did you go for?

O1.

Very nice. I let my sarsquatch go, but still have the modified clip point one. It is a nice in between size that carries well.

Nice piece of hardware!
Will fare well as an all-rounder, think.

Nice. My squatch is going no where!!

That thing is pretty rad, pitman! I bet it's pretty good all around.

Why the big belle nerd the tip.