When reprofiling an edge, is it just as simple as using aggressive grits and progressivly moving to finer grits and just continuous drawing on the "flat" edge?
I reprofiled my mini uncle mojo to a much deeper convex edge, using the mousepad and sandpaper trick. It had some deep gouges in the blade from trying to baton through a hardened masonry nail in a log, so I had to remove a LOT of material. I started with 320 grit wet/dry sandpaper and worked my way down to 2000 grit finish paper. If I wasn't trying to remove tons of steel to get past those gouges, I probably would have started finer.
