After looking at your pic, I pulled mine out of the case and set the dovetail on top of the receiver. What I noticed was that I can line up the front bead with the top of the rear sight, but I cannot put the front bead lower to meet the point of the white diamond on the rear sight, which would be my normal sight picture. Maybe that's not the correct sight picture but it's what I usually use.

So I'm thinking if I wanted to be able to sight the front bead lower I would have to take an angle grinder and make a center groove down the length of the dovetail mount. I don't think this would weaken the mount too much but not sure.